PLANET WGS3-2820 - Manual (Page 513)

User’s Manual of WGS3-2820/WGS3-5220
513
are from (-1 to 255), and the value of -1 is used to indicate that the local interface is not a Candidate RP interface.
The active router interface, with the highest IP Address and crppreference greater than -1, is chosen as the CRP for the router.
The default value is 0.In the CRP advertisements sent to the bootstrap router (BSR), the router interface advertises itself as the
CRP for the group range 224.0.0.0 mask 240.0.0.0.
▫ Default 0
▫ Format ip pimsm crppreference <-1-255>
▫ Mode Interface Config
no ip pimsm crppreference
This command is used to reset the Candidate Rendezvous Point (CRP) for a particular PIM-SM interface to the default value.
▫ Format no ip pimsm crppreference
▫ Mode Interface Config
13.5.4 ip pimsm message-interval
This command is used to configure the global join/prune interval for PIM-SM router. The join/prune interval is specified in
seconds. This parameter can be configured to a value from 10 to 3600.
▫ Default 60
▫ Format ip pimsm message-interval <10-3600>
▫ Mode Global Config
no ip pimsm message-interval
This command is used to reset the global join/prune interval for PIM-SM router to the default value.
▫ Format no ip pimsm message-interval
▫ Mode Global Config
13.5.5 ip pimsm
This command sets administrative mode of PIM-SM multicast routing across the router to enabled. IGMP must be enabled
before PIM-SM can be enabled.
▫ Default disabled
▫ Format ip pimsm
▫ Mode Global Config
no ip pimsm
This command sets administrative mode of PIM-SM multicast routing across the router to disabled. IGMP must be enabled
before PIM-SM can be enabled.
▫ Format no ip pimsm