PLANET WGS3-2820 - Manual (Page 20)

User’s Manual of WGS3-2820/WGS3-5220
20
1.2 How to use This Manual
This User Manual is structured as follows:
Section 2 , Installation
The section explains the functions of the Switch and how to physically install the Switch.
Section 3 , Configuration
The section contains the information about the software function of the Switch.
Section 4 , Web Configuration
The section explains how to manage the switch by Web interface.
Section 5 , Command Structure
The section explains how to manage the switch by Console interface..
Section 6 , Quick Start Up
Section 7, Mode-Base CLI
Section 8 , CLI Command:-Base
Section 9 , CLI Command: Quality of Service
Section 10 , CLI Command: Security
Section 11 , CLI Commands: Switching
Section 12 , CLI Commands: Routing
Appendex A
The section contains cable information of the Switch.
1.3 Product Feature
Physical Ports
24/48 RJ-45 ports for 10/100Base-TX
4 RJ-45 ports for 10/100/1000Base-T
2 shared SFP mini-GBIC interfaces (Shared with Port-51 and Port-52)
One DB9 male/RS-232 console port
Layer 2 Features
Support auto MDI/MDI-X on all 10/100Base-TX and 10/100/1000Base-T ports
The 10/100Base-TX and 10/100/1000Base-T ports support auto-sensing, auto-negotiation
Supports Jumbo frame up to 9KB on 10/100/1000Base-T ports
Provides wire speed of L2 switching performance
Support sup to 16K MAC address entries
Supports Flow Control
− IEEE 802.1x for Full-Duplex mode
− Back-Pressure Flow Control in Half-Duplex mode
Provides Store-and-Forward forwarding scheme
Provides Broadcast storm protection
Supports IGMP snooping v1, v2