PLANET WGS3-2820 - Manual (Page 442)

User’s Manual of WGS3-2820/WGS3-5220
442
OSPF NSSA T1 This field displays the OSPF NSSA Type-1 route preference value.
OSPF NSSA T2 This field displays the OSPF NSSA Type-2 route preference value.
RIP This field displays the RIP route preference value.
BGP4 This field displays the BGP-4 route preference value.
"
Note : The configuration of NSSA preferences is not supported in this release.
12.2.26 show ip stats
This command displays IP statistical information. Refer to RFC 1213 for more information about the fields that are displayed.
▫ Format show ip stats
▫ Modes Privileged EXEC
User EXEC
12.3 Router Discovery Protocol Commands
This section describes the commands you use to view and configure Router Discovery Protocol settings on the switch. The
Router Discovery Protocol enables a host to discover the IP address of routers on the subnet.
12.3.1 ip irdp
This command enables Router Discovery on an interface.
▫ Default disabled
▫ Format ip irdp
▫ Mode Interface Config
12.3.1.1 no ip irdp
This command disables Router Discovery on an interface.
▫ Format no ip irdp
▫ Mode Interface Config
12.3.2 ip irdp address
This command configures the address that the interface uses to send the router discovery advertisements. The valid values for
are 224.0.0.1, which is the all-hosts IP multicast address, and 255.255.255.255, which is the limited broadcast
address.
▫ Default 224.0.0.1
▫ Format ip irdp address