PLANET WGS3-2820 User Manual
Page 198
User’s Manual of WGS3-2820/WGS3-5220
198
。
Restore Defaults for All Queues
- Restores default settings for all queues on the selected interface.
。
Submit
- Send the updated configuration to the switch. Configuration changes take effect immediately. These
changes will not be retained across a power cycle unless a save is performed.
4.5.5.6 Interface Queue Status
Figure 4-5-31
CoS Interface Queue Status
Selection Criteria
。
Slot/Port
- Specifies all CoS configurable interfaces. The option "Global" represents the most recent global
configuration settings. These may be overridden on a per-interface basis.
Non-Configurable Data
。
Queue ID
- Specifies the queueID.
。
WRR weights / Minimum Bandwidth
- Specifies the WRR weights or Minimum Bandwidth the valid range for WRR
weights is 1 to 15. minimum guaranteed bandwidth allotted to this queue when scheduling is WFQ.
。
Scheduler Type
- Specifies thei type of scheduling used for this queue. the scheduling on a interface can be one the
following
strict
wfq
wrr
strict + wrr
strict + wfq
。
Queue Management Type
- Queue depth management technique used for queues on this interface. This is only
used if device supports independent settings per-queue.
Queue Management Type can only be one of the following:
taildrop