PLANET WGS3-2820 - Manual (Page 448)

User’s Manual of WGS3-2820/WGS3-5220
448
12.5.7 ip vrrp priority
This command sets the priority value for the virtual router configured on a specified interface. The priority of the interface is a
priority integer from 1 to 254. The parameter is the virtual router ID which has an integer value ranges from 1 to 255.
▫ Default 100
▫ Format ip vrrp priority <1-254>
▫ Mode Interface Config
12.5.7.1 no ip vrrp priority
This command sets the default priority value for the virtual router configured on a specified interface.
▫ Format no ip vrrp priority
▫ Mode Interface Config
12.5.8 ip vrrp timers advertise
This command sets the frequency, in seconds, that an interface on the specified virtual router sends a virtual router
advertisement.
▫ Default 1
▫ Format ip vrrp timers advertise <1-255>
▫ Mode Interface Config
12.5.8.1 no ip vrrp timers advertise
This command sets the default virtual router advertisement value for an interface.
▫ Format no ip vrrp timers advertise
▫ Mode Interface Config
12.5.9 show ip vrrp interface stats
This command displays the statistical information about each virtual router configured on the switch.
▫ Format show ip vrrp interface stats
▫ Modes Privileged EXEC
User EXEC
Uptime The time that the virtual router has been up, in days, hours, minutes and seconds.
Protocol Represents the protocol configured on the interface.
State Transitioned to
Master
Represents the total number of times virtual router state has changed to MASTER.
Advertisement Received Represents the total number of VRRP advertisements received by this virtual router.
Advertisement Interval
Errors
Represents the total number of VRRP advertisements received for which advertisement
interval is different than the configured value for this virtual router.