23 set garp timer join all, 24 set garp timer leave, 25 set garp timer leave all – PLANET WGS3-2820 User Manual
Page 354
User’s Manual of WGS3-2820/WGS3-5220
354
8.6.23 set garp timer join all
This command sets the GVRP join time for all ports and per GARP. Join time is the interval between the transmission of GARP
Protocol Data Units (PDUs) registering (or re-registering) membership for a VLAN or multicast group.
This command has an effect only when GVRP is enabled. The time is from 10 to 100 (centiseconds)
▫
Default
20 centiseconds (0.2 seconds)
▫
Format
set garp timer join all <10-100>
▫
Mode
Global Config
8.6.23.1 no set garp timer join all
This command sets the GVRP join time for all ports and per GARP to 20 centiseconds (0.2 seconds). This command has an
effect only when GVRP is enabled.
▫
Format
no set garp timer join all
▫
Mode
Global Config
8.6.24 set garp timer leave
This command sets the GVRP leave time per port. Leave time is the time to wait after receiving an unregister request for a
VLAN or a multicast group before deleting the VLAN entry. This can be considered a buffer time for another station to assert
registration for the same attribute in order to maintain uninterrupted service time is 20 to 600 (centiseconds).
▫
Default
60 centiseconds (0.6 seconds)
▫
Format
set garp timer leave <20-600>
▫
Mode
Interface Config
#
Note
:
This command has an effect only when GVRP is enabled.
8.6.24.1 no set garp timer leave
This command sets the GVRP leave time per port to 60 centiseconds (0.6 seconds).
▫
Format
no set garp timer leave
▫
Mode
Interface Config
#
Note
:
This command has an effect only when GVRP is enabled.
8.6.25 set garp timer leave all
This command sets the GVRP leave time for all ports. Leave time is the time to wait after receiving an unregister request for a
VLAN or a multicast group before deleting the VLAN entry. This can be considered a buffer time for another station to assert