PLANET WGS3-2820 User Manual
Page 270
User’s Manual of WGS3-2820/WGS3-5220
270
o
Number Of Packets For Which Group Not Found
- The number of multicast packets that were supposed to be
routed but for which no multicast route was found.
o
Protocol
- The multicast routing protocol presently activated on the router, if any.
o
Table Entry Count
- The number of multicast route entries currently present in the Multicast route table.
o
Table Highest Entry Count
- The highest number of multicast route entries that have been present in the Multicast
route table.
Command Buttons
o
Submit
- Send the updated configuration to the router. Configuration changes take effect immediately. These
changes will not be retained across a power cycle unless a save is performed.
4.7.1.2 Multicast Interface Configuration
Figure 4-6-50
Multicast Interface Configuation
Selection Criteria
o
Slot/Port
- Select the routing interface you want to configure from the dropdown menu.
Configurable Data
o
TTL Threshold
- Enter the TTL threshold below which a multicast data packet will not be forwarded from the
selected interface. You should enter a number between 0 and 255. If you enter 0 all multicast packets for the
selected interface will be forwarded. You must configure at least one router interface before you will see this field.
Command Buttons
o
Submit
- Send the updated configuration to the router. Configuration changes take effect immediately. These
changes will not be retained across a power cycle unless a save is performed.