PLANET WGS3-2820 - Manual (Page 405)

User’s Manual of WGS3-2820/WGS3-5220
405
10.1.3 clear radius statistics
This command is used to clear all RADIUS statistics.
▫ Format clear radius statistics
▫ Mode Privileged EXEC
10.1.4 dot1x defaultlogin
This command assigns the authentication login list to use for non-configured users for 802.1x port security. This setting is
over-ridden by the authentication login list assigned to a specific user if the user is configured locally. If this value is not
configured, users will be authenticated using local authentication only.
▫ Format dot1x defaultlogin
▫ Mode Global Config
10.1.5 dot1x initialize
This command begins the initialization sequence on the specified port. This command is only valid if the control mode for the
specified port is 'auto'. If the control mode is not 'auto' an error will be returned.
▫ Format dot1x initialize
▫ Mode Privileged EXEC
10.1.6 dot1x login
This command assigns the specified authentication login list to the specified user for 802.1x port security. The
parameter must be a configured user and the parameter must be a configured authentication login list.
▫ Format dot1x login
▫ Mode Global Config
10.1.7 dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will transmit an EAPOL EAP
Request/Identity frame before timing out the supplicant. The value must be in the range 1 - 10.
▫ Default 2
▫ Format dot1x max-req
▫ Mode Interface Config
10.1.7.1 no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will transmit an EAPOL EAP
Request/Identity frame before timing out the supplicant to the default value, i.e. 2.
▫ Format no dot1x max-req
▫ Mode Interface Config