PLANET XGSW-28040HP - Manual (Page 81)

Command Guide of XGSW-28040HP
Switch (config)# evc 1 vid 2 interface GigabitEthernet 1/1-2 ivid 3 learning disable
policer 4
4.2.52 evc ece
Command:
evc ece direction {both | nni-to-uni | uni-to-nni} evc {
1-4096> | none} frame-type {any | ipv4 | ipv6} inner-tag { add {dei |
pcp | preserve | type [c-tag | none | s-custom-tag | s-tag] | vid
}, match {dei [ | any]| pcp [ |
any] | type [any | c-tagged | s-tagged | tagged | untagged] | vid [ |
any]} } interface [* | 10GigabitEthernet | GigabitEthernet] next [
1-4096> | last] outer-tag { add {dei | pcp | preserve |
type [c-tag | none | s-custom-tag | s-tag] | vid }, match {dei
[ | any]| pcp [ | any] | mode [disable | enable] | vid
[ | any] } policer { | discard | evc | none} policy
pop
ECE idenfifier
direction Setup ECE direction
both Bidirectional traffic flow
nni-to-uni NNI-to-UNI traffic flow
uni-to-nni UNI-to-NNI traffic flow
evc EVC mapping
EVC identifier
none Map to no EVC ID
frame-type Setup matched frame type
any Match any frame type
ipv4 Match IPv4 frames
ipv6 Match IPv6 frames
inner-tag Setup inner tag options
add Setup inner tag add properties.
dei Setup added tag DEI
Added tag DEI
pcp Setup added tag PCP
Added tag PCP
-81-