PLANET XGSW-28040HP - Manual (Page 303)

Command Guide of XGSW-28040HP
Example:
To exit current mode.
Switch# configure terminal
Switch (config)# snmp-server host planet
Switch (config-snmps-host)#exit
Switch (config)#
4.2.212.4 host
Command:
host [ | | ] { informs |
traps }
host host configuration
hostname of SNMP trap host
IP address of SNMP trap host
IP address of SNMP trap host
UDP port of the trap messages
informs Send Inform messages to this host
traps Send Trap messages to this host
Default:
None
Usage Guide:
To configure Trap Host of SNMP
Example:
To configure Trap Host (below table) of SNMP
Switch# configure terminal
Switch (config)# snmp-server host planet
Switch (config-snmps-host)# host planet.com 66 informs
-303-