PLANET XGSW-28040HP - Manual (Page 166)

Command Guide of XGSW-28040HP
Usage Guide:
To configure IP Subnet-based VLAN for specific interface
Example:
To configure IP Subnet-based VLAN as below table for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # switchport vlan ip-subnet id 1 192.168.1.0/255.255.255.0 vlan 5
4.2.65.133 switchport vlan mac
Command:
switchport vlan mac vlan
switchport Switching mode characteristics
vlan VLAN commands
mac MAC-based VLAN commands
48 bit unicast MAC address: xx:xx:xx:xx:xx:xx
vlan vlan keyword
VLAN ID required for the group to VLAN mapping (Range: 1-4095)
Default:
None
Usage Guide:
To configure MAC-based VLAN for specific interface
Example:
To configure MAC-based VLAN as below table for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # switchport vlan mac 00:55:44:33:22:11 vlan 5
-166-