PLANET XGSW-28040HP - Manual (Page 254)

Command Guide of XGSW-28040HP
Switch# configure terminal
Switch (config)# mep 1 tst 3 dei mep-id 2 sequence one-zero rate 10 size 68
4.2.144 mep up
Command:
mep [mip] up domain { port | evc | vlan } [ vid ] flow level
interface
mep Maintenance Entity Point
The MEP instance number.
mip This MEP instance is a half-MIP
up This MEP is a Up-MEP
domain The domain of the MEP
evc This MEP is a EVC domain MEP.
port This MEP is a Port domain MEP.
vlan This MEP is a VLAN domain MEP.
flow The flow instance that the MEP is related to.
The flow instance number when not in the port domain.
vid In case the MEP is a port Up-MEP or a EVC customer MIP the VID must be given.
The port Domain MEP VID. This is required for a Port Up-MEP.
Default:
None
Usage Guide:
To configure Up-MEP of MEP.
Example:
To configure Up-MEP of MEP 2 as below table
Switch# configure terminal
Switch (config)# mep 2 up domain port vid 1 flow 1 level 2 interface GigabitEthernet
1/1
-254-