PLANET XGSW-28040HP - Manual (Page 80)

Command Guide of XGSW-28040HP
Default:
V2
Usage Guide:
To configure ERPS VLANs for the specific profile.
Example:
To configure ERPS VLANs(VLAN5 - VLAN8) for the specific profile 1.
Switch# configure terminal
Switch (config)# erps 1 vlan add 5-8
4.2.51 evc
Command:
evc vid ivid interface ( * | 10GigabitEthernet |
GigabitEthernet [ ] ) learning [ disable ] policer { |
none | discard }
EVC identifier
vid Setup EVC VLAN ID
EVC VLAN ID
ivid Setup internal EVC VLAN ID
Internal VLAN ID
interface Setup NNI
learning Setup learning
policer Policer (ingress bandwidth profile)
Policer ID
List of VLANs
discard Map to policer discarding all frames
none Map to policer allowing all frames
Default:
0
Usage Guide:
To configure Ethernet Virtual Circuits (EVC).
Example:
To configure Ethernet Virtual Circuits (EVC identifier: 1, EVC VLAN ID: 2, GigabitEthernet Port: 1/1, 1/2, Internal
VLAN ID: 3, Disable learning, Policer ID: 4).
Switch# configure terminal
-80-