Avago Technologies 3ware SAS 9750-4i - Manual (Page 97)

Unit Object Commands
www.lsi.com/channel/products 89
For 9550SX and earlier controllers and for 9650SE and 9690SA running
pre-9.5.1, when you issue this command the specified verify will begin if the
verify schedule is disabled; otherwise it will pause until the next scheduled
verify. If after starting a verify, you enable the Verify Task Schedule, this on-
demand task will be paused until the next scheduled timeslot.
For 9750 controllers, and for 9650SE and 9690SA controllers running
firmware 9.5.1 or later, if verify=basic, the verify will begin immediately. If
verify=advanced, the verify will pause until the next scheduled verify. For
more information, see “/cx set verify=advanced|basic|1..5” on page 72.
Verify will pause if a rebuild, migration, or initialization is currently in
progress.
9000
a Yes Yes Yes N/A Yes Yes Yes Yes
9690SA
and
9650SE Yes Yes Yes Yes Yes Yes Yes Yes
9750 Yes Yes Yes Yes Yes Yes Yes Yes
a. Models 9500S, 9550SX, and 9590SE
Table 10: Manual Verify Behavior (/cx/ux start verify)
9750, and
9650SE and
9690SA with
9.5.1 or later 9650SE and
9690SA with
firmware 9.5 or
9.5.0.1 9550SX and
earlier
Basic Verify Schedule
(verify=basic) Runs
immediately
N/A N/A
Advanced Verify
Schedule
(verify=advanced) Follows
Advanced Verify
Schedule
N/A N/A
Verify Schedule is
Disabled
(verify=disable) Runs
immediately
(Same as Basic)
Runs
immediately Runs
immediately
Verify Schedule is
Enabled
(verify=enable) Follows
Advanced Verify
Schedule
Follows Verify
Schedule Follows Verify
Schedule
Table 9: Supported RAID (Logical Unit) Types for Verification
Model R0 R1 R5 R6 R10 R50 Single Spare