Avago Technologies 3ware SAS 9750-4i - Manual (Page 137)

Enclosure Object and Element Commands
www.lsi.com/channel/products 129
/c x /e x /fan x show
This command is used with 9750 and 9690SA controllers. For the 9650SE,
simply drop the prepended controller name in the command and use /ex.
This command shows the information about the specified enclosure fan /fanx
in the specified enclosure cx/ex. The fan name is followed by its status. If a
fan is on and no fault has been detected, the status will indicate OK.
Example:
//localhost> /c0/e0/fan0 show
---Speed---
Fan Status State Step RPM Identify
------------------------------------------------------------
fan0 OK ON 1 2700 Off
/c x /e x /fan x show identify
This command is used with 9750 and 9690SA controllers. For the 9650SE,
simply drop the prepended controller name in the command and use /ex.
This command shows the identify status of the specified fan. The status can be
either on or off. If identify is on, the LED associated with the fan will blink. If
the enclosure does not support Fan Identify, this command will return N/A.
Example:
//localhost> /c0/e0/fan1 show identify
/c0/e0/fan1 Identify status = on
/c x /e x /fan x set identify=on|off
This command is used with 9750 and 9690SA controllers. For the 9650SE,
simply drop the prepended controller name in the command and use /ex.
If the enclosure supports Fan Identify and there is an LED associated with the
fan, this command causes the LED associated with the fan to blink, or turns
off identification of the LED for this fan.
Example:
//localhost> /c0/e0/fan1 set identify=on
Setting Fan Identify on /c0/e0/fan1 to [on] ... Done.
/c x /e x /fanx set speed=<0..7>
This command is used with 9750 and 9690SA controllers. For the 9650SE,
simply drop the prepended controller name in the command and use /ex.
This command sets the speed level of the specified enclosure fan. The speed
level is a number in the range of <0 . . 7>, where: