Avago Technologies 3ware SAS 9750-4i - Manual (Page 125)

BBU Object Commands
www.lsi.com/channel/products 117
/c x /bbu show attribute [ attribute ...]
This command shows the current setting of the given attribute(s) on the BBU
board. One or many attributes can be specified. Specifying an invalid attribute
will terminate the loop. Possible attributes are: batinst, bootloader, cap, fw,
lasttest, pcb, ready, status, serial, temp, volt.
/cx/bbu show batinst
This command shows the date when the current battery was installed.
/cx/bbu show bootloader
This command shows the BBU's boot loader version.
Note that the BBU bootloader version is not applicable for 9750 models.
/cx/bbu show cap
This command shows the battery capacity in hours.
A value of '0 hours' will be displayed if the battery capacity test has never
been run.
/cx/bbu show fw
This command shows the BBU firmware version number.
Note that the BBU firmware version is not applicable for 9750 models.
/cx/bbu show lasttest
This command shows the date the battery capacity was last measured. If the
battery capacity test has never been run, then 'xx-xxx-xxxx' will be displayed.
Note: The estimated BBU capacity hours displayed is based on the measurement
taken during the last test. If you have not run the BBU test command for some time,
this number can be misleading. You can use the command /cx/bbu show lasttest
to check the date of the last test. For information about running a test, see “/cx/bbu
test [quiet]” on page 120.
Note: The estimated BBU capacity hours displayed is based on the measurement
taken during the last test. If you have not run the BBU test command for some time,
this number can be misleading. For information about running a test, see “/cx/bbu
test [quiet]” on page 120.