Avago Technologies 3ware SAS 9750-4i - Manual (Page 114)

Chapter 2. CLI Syntax Reference
106 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.0
Drive Ports indicates the number of physical ports on the drive. Can be 1 or 2,
depending on whether the drive is a dual-ported drive. SAS drives can be
either single or double ported, while SATA drives have only one port.
Drive Connections indicates the number of connections from the controller
to the drive. Can be either 1 or 2.
Additional information is available using the /cx/px show all command.
Example:
//localhost> /c3/p4 show driveinfo
/c3/p4 Drive Type = SAS
/c3/p4 Interface Type = Direct
/c3/p4 Drive Ports = 2
/c3/p4 Drive Connections = 1
/cx/px show firmware
This command displays the firmware version of the drive attached to the
specified port.
Example:
//localhost> /c0/p5 show firmware
/c0/p5 Firmware Version = 65.13G65
/cx/px show identify
This command only applies to 9750 model controllers and 9000 series SX/SE/
SA model controllers. This feature requires a supported enclosure.
This command shows whether the LED of the drive attached to the specified
port is set to on or off. For details, see “/cx/px set identify=on|off” on
page 113.
Example:
//localhost> /c0/p5 show identify
/c0/p5 Identify Status = on
/cx/px show lspeed
This command only applies to 9750 model controllers and 9000 series SX/SE/
SA model controllers.
This command displays the maximum SATA link speed supported by the
drive attached to the port and the present SATA link speed setting.
Example:
//localhost> /c0/p5 show lspeed
/c0/p5 SATA Link Speed Supported = 3.0 Gb/s
/c0/p5 SATA Link Speed = 3.0 Gb/s