Avago Technologies 3ware SAS 9750-4i - Manual (Page 50)

Chapter 2. CLI Syntax Reference
42 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.0
p23 OK u0 34.25 GB SAS - /c2/e0/slt12 MAXTOR ATLAS15K2_36
p24 OK - 34.25 GB SAS - /c2/e0/slt13 MAXTOR ATLAS15K2_36
p25 OK - 34.25 GB SAS - /c2/e0/slt14 MAXTOR ATLAS15K2_36
p26 OK - 34.18 GB SAS - /c2/e1/slt11 HITACHI HUS151436VL
p27 OK - 34.18 GB SAS - /c2/e1/slt12 HITACHI HUS151436VL
p28 OK - 34.18 GB SAS - /c2/e1/slt13 HITACHI HUS151436VL
p29 OK - 34.18 GB SAS - /c2/e1/slt14 HITACHI HUS151436VL
p30 OK - 34.25 GB SAS - /c2/e0/slt15 MAXTOR ATLAS15K2_36
p31 OK - 34.18 GB SAS - /c2/e1/slt15 HITACHI HUS151436VL
/cx show firmware
This command reports the firmware version of controller /cx.
Example:
//localhost> /c0 show firmware
/c0 Firmware Version = FE9X 3.03.06.X03
/cx show memory
This command reports the available memory on the controller.
Example:
//localhost> /c2 show memory
/c2 Available Memory = 448MB
/cx show model
This command reports the controller model of controller /cx.
Example:
//localhost> /c0 show model
/c0 Model = 9690SA-8E
/cx show monitor
This command reports the monitor (firmware boot-loader) version of
controller /cx.
Example:
//localhost> /c0 show monitor
/c0 Monitor Version = BLDR 2.x
Note: Some memory is reserved for use by the controller, so the amount of
memory available will be less than the controller actually has installed. For
example, the 9690SA controller has 512MB of memory of which 448MB is
available.