Avago Technologies 3ware SAS 9750-4i - Manual (Page 132)

Chapter 2. CLI Syntax Reference
124 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.0
Slot Status VPort Identify
--------------------------------------------------
slot0 OK /c0/p0 Off
slot1 NO-DEVICE - Off
slot2 OK /c0/p1 Off
slot3 OK /c0/p2 Off
slot4 OK /c0/p3 Off
slot5 OK /c0/p4 Off
slot6 OK /c0/p5 Off
slot7 OK /c0/p6 Off
slot8 OK /c0/p7 Off
slot9 OK /c0/p8 Off
slot10 OK /c0/p9 Off
slot11 NO-DEVICE - Off
Alarm Status State Audibility
--------------------------------------------------
alm0 OK OFF UNMUTE
/c x /e x show attribute [ attribute ...]
This command is used with 9750 and 9690SA controllers. For the 9650SE,
simply drop the prepended controller name in the command and use /ex.
This command shows the current setting of the given attribute(s). One or
many attributes can be requested. An invalid attribute will terminate the loop.
Possible attributes are: controllers, slots, fans, temp, pwrs (power supply), and
alms (alarms).
/cx/ex show controllers
This command is used with 9750 and 9690SA controllers. For the 9650SE,
simply drop the prepended controller name in the command and use /ex. This
command is primarily useful for 9650SE controllers, where the enclosure
number may not already be known.
This command lists the controller associated with enclosure /cx/ex.
Example:
//localhost> /e0 show controllers
e0 connects to controller /c0
/cx/ex/ show diag=helptext
This command is used with 9750 and 9690SA controllers. For the 9650SE,
simply drop the prepended controller name in the command and use /ex.
This command allows you to view the enclosure diagnostic log. What is
reported by this log will vary depending upon the manufacturer of the
enclosure. The enclosure diagnostic log may be requested by 3ware Customer
Support to help troubleshoot problems on your controller.