Avago Technologies 3ware SAS 9750-4i - Manual (Page 117)

Port Object Commands
www.lsi.com/channel/products 109
/cx/px show status
This command displays the status of the drive attached to the specified port.
(Definitions of the drive statuses are available in the 3ware SATA+SAS RAID
Controller Card Software User Guide, Version 10.0.)
Example:
//localhost> /c0/p5 show status
/c0/p5 Status = OK
Note: This command only returns the status pertaining to the drive of the
specified port. Its intended use is not for determining the status of a drive
relative to a unit (for that, please use “/cx/px show” on page 104). For
example, if a unit is DEGRADED and a drive is the degradation point of that
unit, the output of this command would not show DEGRADED as the
command
“/cx/px show” would. Note also the difference that this command only shows
the status of the drive; it does not contain other information such as unit, type,
size, and so forth.
/c x /p x show all
This command shows the current setting for all port-related attributes: status,
model, serial, firmware, capacity, and smart.
Example for 9690SA and 9750:
//localhost>
/c3/p3 show all
/c3/p3 Status = OK
/c3/p3 Model = ST3750640AS
/c3/p3 Firmware Version = 3.AAK
/c3/p3 Serial = 3QD0RGX6
/c3/p3 Capacity = 698.63 GB (1465149168 Blocks)
/c3/p3 WWN = 0000000000000000
/c3/p3 Drive Type = SATA
/c3/p3 Interface Type = Direct
/c3/p3 Drive Ports = 1
/c3/p3 Drive Connections = 1
/c3/p3 Link Speed Supported = 1.5 Gbps
/c3/p3 Link Speed = 1.5 Gbps
/c3/p3 Queuing Supported = Yes
/c3/p3 Queuing Enabled = Yes
/c3/p3 Reallocated Sectors = 0
/c3/p3 Power On Hours = 268
/c3/p3 Temperature = 36~C
/c3/p3 Spindle Speed = 7200 RPM
/c3/p3 Identify Status = N/A
/c3/p3 Belongs to Unit = N/A
/c3/p3 Drive Smart Data: