Avago Technologies 3ware SAS 9750-4i - Manual (Page 133)

Enclosure Object and Element Commands
www.lsi.com/channel/products 125
/cx/ex show slots
This command is used with 9750 and 9690SA controllers. For the 9650SE
and CCU enclosure, simply drop the prepended controller name in the
command and use /ex.
This command reports the slots in enclosure /cx/ex and their associated
information. The Slot column lists the slot IDs, the Status column lists the
status of each slot, the (V)Port column shows the associated port or virtual
port of each slot, and the Identify column lists the Identify setting of the slots
Example:
//localhost> /c0/e0 show slots
Slot Status (V)Port Identify
----------------------------------------------------
slot0 OK /c0/p0 No
slot1 OK /c0/p1 Yes
slot2 NO-DEVICE - No
slot3 NO-DEVICE - No
/cx/ex show fans
This command is used with 9750 and 9690SA controllers. For the 9650SE,
simply drop the prepended controller name in the command and use /ex.
This command lists the fans in enclosure /cx/ex and shows their status.
The Status column lists the status of each fan. The State column indicates if
the fan is On or Off. Speed is shown by two columns showing the Step (level)
and RPM (revolutions per minute). There are seven speed levels:
0 - Off
1 - Lowest
2 - Low
3 - Medium-low
4 - Medium
5 - Medium-high
6 - High
7 - Highest
The Identify column lists the Identify setting of the fans.