TA Triumph-Adler LP 4024 - Manual (Page 94)

Using the Operator Panel
1-79
5
Press the ENTER key. A question mark (?) appears.
6
Press the ENTER key. Processing appears, then Waiting. If you
want to abandon writing, press the CANCEL key.
7
In this state, send the file from the computer to the printer as in the
example below.
Example:
To send the file (data) TEST.TXT on drive C, enter the following at
the DOS prompt (C:\):
COPY TEST.TXT PRN
The file is written onto the memory card given a destination name
(also referred to as a partition name) which the printer automatically
assigns one after another as follows:
DataS001 (first data), DataS002 (second data),
DataS003 (third data)...
In the example above, if the file TEST.TXT is the first data to be
written onto the memory card, the destination name will be
DataS001.
As the printer receives data, the message display changes to
Processing, then when the end of the data is received, the message
display changes to Waiting.
ENTER
>Write Data ?
ENTER