New toner, Installed – TA Triumph-Adler LP 4024 User Manual
Page 128
Using the Operator Panel
1-113
Resetting the Remaining Toner Counter
If the toner container was replaced when Replace toner Clean
Printer was not displayed, reset the toner counter as follows so that an
accurate toner gauge measurement is indicated on the status page. Note
that if this operation is performed when the toner cartridge is not replaced,
the toner gauge measurement will not be indicated correctly.
If the type of the toner kit (TK-60/TK-60E) was changed, the toner ID must
also be changed. See
Also refer to the
User's Manual
supplied with the toner kit when
replacing the toner container.
1
Press the MENU key.
2
Press the or key repeatedly until Life Counters > appears.
3
Press the > key.
4
Press the or key repeatedly until >New Toner Installed.
appears
5
Press the ENTER key. A question mark (?) appears.
6
Press the ENTER key. The toner counter is reset.
7
Press the MENU key. The message display returns to Ready.
MENU
Life Counters >
?
>New Toner
Installed
ENTER
>New Toner
Installed ?
ENTER
MENU