TA Triumph-Adler LP 4024 - Manual (Page 102)

Using the Operator Panel
1-87
1
Press the MENU key.
2
Press the or key repeatedly until RAM Disk Mode > appears.
3
The default setting is Off. Press the ENTER key. A blinking question
mark (?) appears. Select On using the or key, and then press
the ENTER key.
4
Press the > key to display >RAM Disk Size.
5
Press the ENTER key again, and change the RAM disk size using the
or key. It is not possible to make a setting that exceeds total
printer memory. The default value for the RAM disk is the total
printer memory minus 9 MB. This parameter may be set anywhere
from 01 to 99 depending on the available printer memory.
If you want to abandon the setting, press the CANCEL key.
6
When the desired RAM disk size is displayed, press the ENTER key.
7
Press the CANCEL key and restart the printer. The setting will be
activated after restart.
MENU
RAM Disk Mode >
Off
ENTER
RAM Disk Mode >
? Off
?
>RAM Disk Size
Mbyte
ENTER
ENTER