TA Triumph-Adler LP 4024 - Manual (Page 125)

Using the Operator Panel
1-110
Setting the Duplex Path
To use this function, the duplexer must be installed on the printer.
If the paper type is set to Custom and the option duplexer is installed on
the printer, you can set whether or not to enable duplex printing as follows.
The default setting is Enable.
1
Display the custom paper type (see Customizing Paper Type on
page 1-107 ) and press the > key.
2
Press the or key repeatedly until >>Duplex path appears.
3
Press the ENTER key. A blinking question mark (?) appears.
4
Select Enable or Disable using the or key. For details of the
default setting for each paper type, see section 4.3 Paper Type on
page 4-11 .
If you want to abandon the setting procedure, press the CANCEL
key.
5
Press the ENTER key.
6
Press the MENU key. The message display returns to Ready.
Option
?
>>Duplex path
Enable
ENTER
>>Duplex path
? Enable
ENTER
MENU