TA Triumph-Adler LP 4024 - Manual (Page 69)

Using the Operator Panel
1-54
Setting the Default Font
You can select the default font for the current interface. In addition to the
internal fonts, all fonts that are downloaded to the printer memory, or fonts
stored on a CompactFlash card, Microdrive, or option ROM, can be selected
as the default font.
In this menu, you can also set the type and pitch for Courier and Letter
Gothic; as well as to print a font list.
Selecting the default font
1
Press the MENU key.
2
Press the or key repeatedly until Font > appears.
3
To select an internal font, check that Internal is displayed and
press the > key. The message display changes to that shown below. If
Internal is not displayed, press the
or key to display it.
To select an option font, press the ENTER key while Font > is
displayed. Press or key repeatedly until the message display
indicates Option and press the ENTER key. Pressing the > key after
that displays the font selection shown above. This operation is
possible only when option fonts are installed in the printer.
The letter before the number indicates the type of font as shown
below:
Letter Description
I Internal font
S Soft (down load) font
M Fonts in an option CompactFlash card
H Fonts in a RAM disk or option Microdrive.
O Fonts in an option ROM
Font >
Internal
MENU
Font >
Internal
?
> I000