TA Triumph-Adler LP 4024 - Manual (Page 116)

Using the Operator Panel
1-101
Setting Duplex Printing
To use this function, the duplexer must be installed on the printer.
Using the option duplexer (DU-60), you can automatically print on both
sides of the paper. The duplexer is mounted underneath the printer. For
details about the installation procedure, see Appendix D and the User's
Manual supplied with the duplexer.
Binding Setups
The term binding refers to the manner in which printed pages of paper are
joined together when pages are joined together (by gluing, stitching, etc.) in
book form. The two possible types of binding are long-edge binding, in
which pages are joined together along their long edge; and short-edge
binding, in which they are joined together along their short edge. In
selecting a binding type, you must also consider the orientation of the
printed page. You can use long-edge or short-edge binding with either
landscape or portrait printing.
Depending on the binding type and print orientation, the duplexer provides
four types of binding setups. These are: (1) portrait, long-edge, (2) portrait,
short edge, (3) landscape, long-edge, and (4) landscape, short-edge. The
figure below shows these binding setups.
Binding Setups
To select duplex printing and binding setup from the operator panel,
proceed as follows. This procedure can only be performed when the option
duplexer (DU-60) is installed.
1
Press the MENU key.
Option
>Duplex Mode >
(1)
(3)
(2)
(4)
Portrait,
long-edge
Landscape,
long-edge
Portrait,
short-edge
Landscape,
short-edge
MENU