TA Triumph-Adler LP 4024 - Manual (Page 60)

Using the Operator Panel
1-45
Changing Network Interface Parameters
This section applies to the printers having the option network card
installed. The FS-1800N/FS-3800N come standard with a network
interface card installed. For details concerning the network when using
the FS-1800N/FS-3800N, refer to the supplied Network Manual .
To make your printer supports Netware, TCP/IP, and EtherTalk networks,
you will need to install the option network interface card in the printer and
make the proper settings as explained in this section.
You can also have a status page for the network interface card printed out
each time the printer is turned on.
1
Press the MENU key.
2
Press the or key repeatedly until Interface > appears. One
of the interface names shown below appears, indicating the current
interface.
Parallel (default)
Serial
Option
3
Press the ENTER key. A blinking question mark (?) appears.
4
Press the or key repeatedly until Option appears.
5
Press the ENTER key again.
Option
MENU
ENTER
Interface
? Parallel
Interface
? Option
ENTER