TA Triumph-Adler LP 4024 - Manual (Page 61)

Using the Operator Panel
1-46
6
Press the > key. Each time the or key is pressed, the display
changes as shown below.
7
The following example explains how to activate TCP/IP protocol to
connect the printer in the network. You can select Netware or
EtherTalk in a similar manner.
If TCP/IP is currently Off is displayed, select On using the or
key. Press the ENTER key again.
?
>NetWare >
On
>TCP/IP >
On
>EtherTalk
Off
>Opt. StatusPage
On
This is the network interface card
status page print menu. See page 1-48 .
ENTER
>TCP/IP >
On
>TCP/IP
? On >TCP/IP >
On