TA Triumph-Adler LP 4024 - Manual (Page 118)

Using the Operator Panel
1-103
Selecting the Output Device
You can select whether printouts will be received by the face-down output
tray or to the face-up output tray. If an option sorter is installed, it can also
be selected.
1
Press the MENU key.
2
Press the or key repeatedly until Paper Handling >
appears.
3
Press the > key.
4
Press the or key repeatedly until >Stack Select appears.
5
Press the ENTER key. A blinking question mark (?) appears.
6
Press the or key to display the desired destination. The output
tray changes as shown below.
Face-down tray (Printer's face-down output tray) [Default]
Face-up tray
(Printer's face-up output tray) [Option face-up
tray required]
Option stacker (Displayed when option output device is
installed such as SO-60)
7
When the desired paper source displayed, press the ENTER key.
8
Press the MENU key. The message display returns to Ready.
>Stack Select
MENU
Paper Handling >
?
>Stack Select
Face-down tray
ENTER
>Stack Select
? Face-down tray
ENTER
MENU