TA Triumph-Adler LP 4024 - Manual (Page 20)

Understanding the Operator Panel
1-5
Keys
The operator panel keys are used to
configure the printer. Note the
certain keys have the secondary
function.
Settings made with these keys effect only the interface currently in use.
GO
CANCEL MENU ENTER
?
Note
Key Function
• Switches the printer on-line and off-line.
• Prints and feed out one page.
• Cancels a printing job.
To cancel, proceed as follows:
1 Check if Processing is displayed in the message display.
2 Press the CANCEL key.
3 Print Cancel? appears in the message display and then interface to be canceled.
Parallel
Serial
Option (appears only when an option network interface card is installed)
Press the CANCEL key again if you wish to stop the cancellation of printing.
4 Select the interface to cancel using the or key and then press the ENTER key.
Printing from the selected interface will stop. Cancelling data appears in the message
display and printing stops after the current page is printed.
• Resets numeric values, or cancels a setting procedure.
• Used to stop the sounding of the alarm buzzer an error occurs.
• When pressed during mode selection, terminates the setting and the printer returns to the
Ready condition.
• Used to select the emulation, font, character code set; to read an CompactFlash card, and
more.
Used to access a desired item or enter numeric values. In some of the control procedures, the <
and > keys are used to enter or exit a sub item.
Used to access a desired item or enter of numeric values. In some of the control procedures, the
< and > keys are used to enter or exit a sub item.
Used as the < key in the mode selection function.
• Used as the > key in the mode selection function.
• Displays online help messages on the message display when paper jam errors occur. When
pressed in the Ready condition, displays explanations of online help messages. When pressed
while the online help is displayed, cancels the online help.
Finalizes numeric values and other selections.
GO
CANCEL
MENU
?
ENTER