TA Triumph-Adler LP 4024 - Manual (Page 200)

Expanding the Printer Memory
B-2
B.1 Expanding the Printer Memory
This section explains how to expand the printer's memory. Expanded
printer memory enables you to print more complex pages, download more
fonts, and define more macros.
This section first explains how to remove the main circuit board and then
how to install a DIMM (Dual In-line Memory Module) on the main circuit
board.
The FS-1800/FS-1800N comes supplied with 8 MB of memory installed,
and the FS-3800/FS-3800N comes with 16 MB of memory installed. Two
sockets are provided for expanding the printer memory to allow more
complex printing jobs and increase the printing speed. By installing
DIMMs into your printer, the memory in the FS-1800/FS-1800N can be
increased to a maximum of 264 MB, and that in the FS-3800/FS-3800N can
be increased to a maximum of 272 MB.
The expansion memory should be installed only by a Kyocera Mita
authorized dealer or Kyocera Mita certified technician. Kyocera Mita shall
not be liable for damage due to improper installation of the expansion
memory.
The minimum memory requirements for the printer with various options
installed are listed in the table below. Please refer to this table when
expanding the printer's memory.
Note
Printing condition
Resolution
300 dpi 600 dpi
1200 dpi
Fast mode Fine mode
PCL6, duplex mode = None 8 MB 8 MB 8 MB 8 MB
PCL6, duplex mode = On 8 MB 8 MB 8 MB 16 MB
KPDL, duplex mode = None 8 MB 8 MB 8 MB 8 MB
KPDL, duplex mode = On 8 MB 8 MB 16 MB 16 MB
PCL6/KPDL resource
protection,
duplex mode = None
– 16 MB 16 MB 16 MB
PCL6/KPDL, resource
protection,
duplex mode = On – 16 MB 16 MB 16 MB