TA Triumph-Adler LP 4024 - Manual (Page 90)

Using the Operator Panel
1-75
Adjusting the Print Density
The print density can be adjusted in five steps: from 01 (light) to 05 (dark).
The factory setting is 03.
1
Press the MENU key.
2
Press the or key repeatedly until Print Quality > appears.
3
Press the > key.
4
Press the or key repeatedly until >Print Density appears.
5
Press the ENTER key. A blinking question mark (?) appears.
6
Select the print density from five steps from 01 (light) to 05 (dark)
using the or key.
If you want to abandon the setting procedure, press the CANCEL
key.
7
Press the ENTER key.
8
Press the MENU key. The message display returns to Ready.
>Print Density
MENU
Print Quality >
?
>Print Density
03
ENTER >Print Density
? 03
ENTER
MENU