TA Triumph-Adler LP 4024 - Manual (Page 72)

Using the Operator Panel
1-57
Changing the Font Size
You can change the size of the default font. If the default font is a fixed font
such as Courier or Letter Gothic, the character pitch can be changed
instead of the font size.
1
Press the MENU key.
2
Press the or key repeatedly until Font > appears.
3
Check that Internal is displayed and press the > key.
4
Press the or key repeatedly until >Size appears.
5
Press the ENTER key. A blinking cursor ( _ ) appears.
6
Press the or key to increase or decrease the value of the figure
where the cursor is blinking. The font size can be set between 4 and
999.75 points, in 0.25-point increments. You can use the > or < key to
move the cursor right and left.
If you want to abandon the setting procedure, press the CANCEL
key.
7
When the desired size is displayed, press the ENTER key.
8
Press the MENU key. The message display returns to Ready.
>Size
MENU
Font >
Internal
?
>Size
012.00 point(s)
ENTER >Size
012.00 point(s)
ENTER
MENU