TA Triumph-Adler LP 4024 - Manual (Page 214)

RS-232C Cable Connection
C-10
5
The printer RS-232C parameters are factory-set to the following
values:
Baud rate=9600 bps, data bits (character length)=8 bits, stop bits=1,
parity=none
The two RS-232C protocols are XON/XOFF and DTR. The printer
performs both of them simultaneously, using positive logic for DTR.
If you are uncertain as to the printer's current parameter settings,
you can reset them to the values listed above by following the
procedure explained in Printer Resetting on page 1-123 .
6
Set the computer to the same parameters as the printer. On many
computers this can be done by setting DIP switches before the power
is turned on. Another method is as follows:
C.4.3 Setting the RS-232C Parameters
Windows 95/98
1
Click on Start button in the Windows 95/98 task bar and align the
cursor with Settings, then click on Control Panel from among the
items displayed.
2
The control panel folder opens. Double click on System.
3
System Properties opens. Click on the Device Manager tab, then
click on the COM port to be used.
4
Click on Properties button.