TA Triumph-Adler LP 4024 - Manual (Page 55)

Using the Operator Panel
1-40
Changing the Interface Parameters
The printer is equipped with both a parallel and serial interface. In
addition, the N version model has an Ethernet network interface. Various
printing environment parameters such as the default emulation can be
changed indepently on different interfaces by using the printer's menu
selection system. Before select the interface to apply the changes in the
procedure described below.
This interface selection described below does not select which interface
data will be received from. The printer automatically selects an interface
data is received.
Changing Parallel Interface Modes
The parallel interface mode of this printer supports a bi-directional/high-
speed mode. Normally, this interface is used under the default setting
Nibble (high). For details, see
Appendix C . After setting the interface,
be sure to reset the printer or turn the power off at least once. The new
setting will be enabled thereafter.
1
Press the MENU key.
2
Press the or key repeatedly until Interface > appears. One
of the interface names shown below appears, indicating the current
interface.
Parallel (default)
Serial
Option (with the FS-1800N/FS-3800N or when a network interface
card is installed)
3
Press the ENTER key. A blinking question mark (?) appears.
If Parallel is not displayed, press the or key repeatedly until
it is Parallel.
If you want to abandon the interface selection procedure, press the
CANCEL
key. The interface remains unchanged.
4
Press the ENTER key again.
Interface >
Parallel
Note
MENU
ENTER Interface
? Parallel
ENTER