RISCO Group Gardtec GT600 - Manual (Page 90)

Page 88
GT 600 / 601 Engineer’s Reference Guide
34) Press No. The display will show:-
35) Press Yes. The display will show:-
36) Press No until the required setting is displayed,
then press Yes. The display will show:-
37) Press No. The display will show:-
38) Press Yes. The display will show:-
39) Press No until the required setting is displayed,
then press Yes. The display will show:-
40) Press No. The display will show:-
41) Press Yes. The display will show:-
Options available are:
Always On
Keypad(s) are always On
*Off in E/E Keypad(s) not available during
Entry/Exit. ACE must be used.
*Off in E/E/Alm Keypads not available during
Entry/Exit or if E/E has gone
through to an alarm
*One of these options will be required by your inspectorate.
42) Press No until the required setting is displayed,
then press Yes. The display will show:-
43) This concludes the Program Alarm Confirm
Press 0 (zero) three times to return to:-
Program Confirm
Comms. Restore ?
Program Confirm
Keypad Opening ?
Program Confirm
Keypad Opening ?
Keypad Opening
= Always On
Program Confirm
Comms. Restore ?
Comms. Restore
= On
01 Jan 00: 00: 01
Program Confirm ?
ACE Bat. Monitor
ACE Bat. Monitor
=On
Program Confirm ?
ACE Bat. Monitor