RISCO Group Gardtec GT600 - Manual (Page 21)

Page 19
GT 600 / 601 Engineer’s Reference Guide
38) Press No until the required setting is displayed
then press Yes. The display will show:-
39) Press No until the required setting is displayed
then press Yes. The display will show:-
40) Repeat from Step 39 until all the ZEX Expanders
you require have been programmed.
The display will show:-
41) Press No. The display will show:-
42) Press Yes. The display will show:-
Any 12Hr type zone(s) may be placed on Test. A Zone on Test will never trigger
an alarm or send a central station signal. If the Zone(s) fails the Test when the
system is Set, the display will show Test Fail when the user Un-Sets the system.
After 20 successful Sets and Un-Sets, the Zone(s) will be taken out of Test by the
system.
ZEX 2 Wiring
= Off
Program Zone
Wiring ?
Program Zone
Attributes ?
Test None
ZEX 1 Pairing
= Off