RISCO Group Gardtec GT600 - Manual (Page 63)

Page 61
GT 600 / 601 Engineer’s Reference Guide
Programming PGM2 / 3 / Timers
PGM2 refers to the PGM2 terminal on the control panel PCB situated near to the
speaker terminals.
PGM3 Refers to the Strobe terminal, if this is not used for the Strobe (for example if a
NovActive Bell Box is used) it may be re-programmed for other uses.
One Timer is also available. It should be noted that the times programmed will operate
seven days per week, you are not able to program separate time for weekends etc.
1) Enter into Engineer Mode
To do this follow Steps 1 to 4 on page 11
With the display showing:-
2) Press No eight times. The display will show:-
3) Press Yes. The display will show:-
4) Press Yes. The display will show:-
Options available for PGM2 / 3 are.
Bell
Alert
Any-Fire
Any-Panic
Alarm
(Unconfirmed)
AlarmB (Confirmed)
Alm Abort (Alarm Abort)
O/C Cleaner
Cleaner Set
Gen.Tamper
Zone-24Hr
Part-Set
Program . . . . _ _ _
Zones ?
Program . . . . _ _ _
PGM2 / 3 / Timers ?
Program PGM2 / 3
Operating Modes ?
PGM2 O/P
=Bell
=+V