RISCO Group Gardtec GT600 - Manual (Page 8)

3 P
ROGRAMMING
Moving Around
Enter Engineer mode as described on page 3.
The display will show:-
Whenever three underscores are shown on the display the screen is a Header.
Pressing the NO key will move to the next Header.
Pressing the YES key whilst viewing a Header will enter into the options under that
Header.
Pressing 0 will escape back one step (except when a numeric entry is required).
You are able to jump to various common options when programming by entering the
relevant menu numbers. With a Header showing, key in the appropriate menu
number, then press Yes. (See Pages 9 & 10 for Common Options with Menu
Numbers).
Below is given a complete list of headers (Shown in Bold Underline) and options that
appear under each header.
Page 6
GT 600 / 601 Engineer’s Reference Guide
Program . . . . _ _ _
Zones ?
Headers & Options
Program Zones
Zone Types
Zone Descriptors
Zone Wiring
Zone Attributes
(Test/Part/Cleaner/Chime/Walk/Sec/Per)
Zone Double Knock/Arm/Log
Zone E/E Mode
Event Tags
Setting Modes
Setting For Full Sets
Setting For Part 1 Sets
Setting For Part 2 Sets
Setting For Part 3 Sets
Setting Delay
Setting Sounders
Setting Conformation
Auto Part Set
Headers & Options
Entry Times
Entry Time 1
Entry Time 2
Bells / Sounders
Bell Type
Bell Delay/No Arms
Bell & Sounder Ring
Bell Tamper Mode
Bell For Part Set