RISCO Group Gardtec GT600 - Manual (Page 47)

Page 45
GT 600 / 601 Engineer’s Reference Guide
19) Press No. The display will show:-
20) Press Yes. The display will show:-
21) Press No until the setting you require is displayed
then press Yes. The display will show:-
22) Press No. The display will show:-
23) Press Yes. The display will show:-
Options available are.
Auto Only ACE units will be auto recognised when
programming them onto the system.
Auto/Manual The system will ask ‘Is this Code For
ACE’ when programming codes onto
the system.
24) Press No until the required setting is displayed
then press Yes. The display will show:-
25) Press No until the required setting is displayed
then press Yes. The display will show:-
26) This concludes the programming for
Keypad. Press 0 (zero) to return to:-
Or
Press 0 (zero) until the display show:-
Program Keypad
Backlight Mode ?
Program Keypad
Backlight Mode ?
Program Keypad
ACE/Prox ?
ACE Installation
= Auto - Only
Backlight . . .
= On if EE/Key
Program . . . . _ _ _
Keypad ?
01 Jan 00: 00: 01
Prox Tamp. Detect
=Off
Program Keypad
ACE/Prox ?