RISCO Group Gardtec GT600 - Manual (Page 49)

Page 47
GT 600 / 601 Engineer’s Reference Guide
5) Press No until the required option is displayed.
Then press Yes. The display will show:-
Note: If On is selected, the Vo-Comm menu will now appear in
the USER mode. Please refer to GT 600 / 601 User Guide
for further programming information.
6) Press No until the required option is displayed.
Then press Yes. The display will show:-
7) Press No twice to turn the STU adaptor On.
The display will show:-
8) Press Yes. The display will show:-
Press No until the required option is displayed.
Then press Yes.
Note: Pos:- STU Adaptor Ch. O/Ps & Pin 11 (ATS) are + 5V active.
Neg:- STU Adaptor Ch. O/Ps & Pin 11 (ATS) are 0V active.
9) The display will show:-
Press No until the required option is displayed.
Then press Yes.
Note: Pos:- RC Reset (Pin 6), FTC (Pin 7), LF (Pin 15) are +5V active.
Neg:- RC Reset (Pin 6), FTC (Pin 7), LF (Pin 15) are 0V active.
10) The display will show:-
Leave as default when connecting to a STU.
11) Press Yes. The display will show:-
Testing the channels should be conducted after the
STU has been configured and enabled.
12) Press Yes. The display will show:-
13) Press Yes. The display will show:-
VoComm
=Off
STU Adaptor
=Off
STU Adaptor
>On
STU Adaptor O/P
=Pos
STU Adaptor I/P
=Pos
STU Adaptor Pin 7
=Power O/P
Test Digicom
Channels ?
Make a STU
Test Call ?
Test Chan. is On
Restore ?