RISCO Group Gardtec GT600 - Manual (Page 72)

Page 70
GT 600 / 601 Engineer’s Reference Guide
8) Press No. the display will show:-
Choose from one of the options displayed.
9) The display will show:-
10) Press No until the required setting is displayed
then press Yes. The display will show:-
With Expander 1 / Output 1 programmed as Bell, the output will operate with the Bell
when this is set as +V. With this set as -V the output will be inverted, e.g On, turning
Off with the Bell.
11) Repeat the sequence for Expanders O/P 2 - 4 if required.
12) With the display showing:-
Press Yes.
13) The display will show:-
Press No to change the Cus 1 to Zone, Code or
Group as required to follow. Press Yes.
14) The display will show:-
15) Press No. The display will show:-
Cus 1 = Zone #=000
=Day = Fol+ t=00
Cus 1 = Zone #>000
=Day = Fol+ t=00
Choose 1=A1 2=A2
3=A3 4=All 5=Any
Expander 1 O/P 1
>Off =+V
Expander 1 O/P 1
=Off >+V
Expander 4 O/P 4
=Off =+V
Cus 1 = Zone #>_ _ _
=Day = Fol+ t=00