RISCO Group Gardtec GT600 - Manual (Page 10)

In conclusion, the Yes and No Keys are used to navigate. The No Key is also used to
change a value (may also require a numeric input) and the Zero Key is used to move
back a level (not when the display is expecting a numeric input).
If you are confident in programming the GT 600 / 601 Control Panels please use the
headers and options above to continue or alternatively use the appropriate menu
numbers. (See Pages 9 & 10).
Otherwise
Please continue with the next section for a Step by Step Guide to programming the GT
600 / 601 Control Panels.
Only the major options will be covered in this Step by Step Guide. After
completing the guide you should be confident to program the remaining options.
Page 8
GT 600 / 601 Engineer’s Reference Guide
Headers & Options
Service
Mains OK 50Hz
Save Panel NVM to PTM
Load Panel NVM to PTM
Service Timer On/Off
Time To Next Service
Service Tel No.
Lock-Out On/Off
Engineer Mode Constant/Timed
Custom Screens
LCD Status Display
(To conform with EN standards, LCD Status is
defaulted to Off and cannot be changed)
LED Status Display
Custom Display On/Off
Program Text
Diagnostics / Log
List Event Log
Change List Diagnostics
PSU Diagnostics
NovActive Diagnostics
PSU Test Time
Change / List Test Limits
Aux Volts
Battery Volts On Charge
Battery Volts Off Charge
Headers & Options
Alarm Confirm
Window Time
On Entry
Sounder Mode
Reset Mode
Secondary Time
ET Mode
Bell Mode
Strobe Mode
Start Delay
Comms Restore
Keypad Opening
ACE Battery Monitor