RISCO Group Gardtec GT600 - Manual (Page 123)

Page 121
GT 600 / 601 Engineer’s Reference Guide
Testing the Battery Charge Voltage
IMPORTANT
To test the Battery Charge Voltage the battery must be connected to the battery leads
first. (See figure 1).
Once the
battery is
connected, the charge is switched on. Note, the battery voltage is dropped every 10
seconds to check the battery.
To test the charge voltage, connect a test meter as per figure 2.
Connect one meter lead to the battery by pushing the probe under the insulation of the
battery spade.
Then remove the other battery lead and connect to the other meter lead. The meter will
now show the battery charge voltage. Note that the voltage will drop off after 10
seconds. Repeat the above if required.
Fig 1.
Fig 2.