RISCO Group Gardtec GT600 - Manual (Page 77)

Page 75
GT 600 / 601 Engineer’s Reference Guide
15) Press No until the required setting is displayed
then press Yes. The display will show:-
With Engineer Mode programmed as Constant
the panel will remain in Engineer Mode until
the Engineer exits.
With Engineer Mode programmed as timed the
panel will jump out of Engineer Mode after 1 hour
if all the Tampers are clear. This prevents the
Engineer accidentally leaving the panel in
Engineer Mode.
16) Press No until the required setting is displayed,
then press Yes. The display will show:-
17) This concludes the Program Service.
Press 0 (zero) until the display shows:-
Engineer Mode
= Constant
Program . . . . _ _ _
Service / PTM ?
01 Jan 00: 00: 01