RISCO Group Gardtec GT600 - Manual (Page 61)

Page 59
GT 600 / 601 Engineer’s Reference Guide
Programming Panic / Duress
Note: Duress is defaulted to Off and cannot be changed. Duress 7 is now no
longer available.
You should also check current legislation if Panic & Duress signals are allowed for the
grade of system that you are fitting.
1) Enter into Engineer Mode
To do this follow Steps 1 to 4 on page 11
With the display showing:-
2) Press No seven times. The display will show:-
3) Press Yes. The display will show:-
It should be noted that with PA = Bells Only no PA signals will be sent to Central
Station.
Available setting for PA are
Bells Only Activating a Panic will only sound the Bells.
Bells Always Activating a Panic will Sound the Bells and send a signal
to Central Station provided that a Digi Channel is
programmed as Panic.
Silent Always Activating a Panic will only send a signal to Central Station
providing that a Digi Channel has been programmed as
Panic.
Bells if LFlt As Silent Always but will revert to Bells if a Linefault is
present.
Program . . . . _ _ _
Zones ?
Program . . . . _ _ _
Panic / Duress ?
PA = Bells Only
= Non-Testable