Emerson Process Management ControlWave XFC - Manual (Page 81)

CI-ControlWave XFC Service / 3-5
Watchdog LED ON = Watchdog Condition – OFF = Normal Operation
Idle LED
ON = Idle - Note: To save power, the IDLE LED should be ON for only 2
seconds every minute, i.e., 2 out of 60 seconds.
3.3.4 Wiring/Signal Checks
Check I/O Field Wires at the Terminal Blocks on the Terminal Plate. Check wiring for con-
tinuity, shorts & opens. Check I/O signals at their respective Terminal Blocks (see Figure 3-
2).
Figure 3-2 - Terminal Plate Field I/O Wring Diagram