Emerson Process Management ControlWave XFC User Manual
Page 192
4
ESDS Manual
#S14006
4/15/92
(6)
It is important to note when inserting EPROMS/PROMS, that the index notch on
the PROM must be matched with the index notch on the socket. Before pushing
the chip into the socket, make sure all the pins are aligned with the respective
socket-holes. Take special care not to crush any of the pins as this could destroy
the chip.
(7)
Power the system down before removing or inserting comb connectors/plugs or
removing and reinstalling PC boards or ESD-sensitive components from card
files or mounting hardware. Follow the power-down procedure applicable to the
system being serviced.
(8)
Handle all defective boards or components with the same care as new compo-
nents. This helps eliminate damage caused by mishandling. Do not strip used PC
boards for parts. Ship defective boards promptly to Bristol Babcock in a static-
shielding bag placed
inside
static-shielding foam and a box to avoid damage
during shipment.
Typical Chip Removal Tool