Emerson Process Management ControlWave XFC - Manual (Page 76)

2-34 / Installation & Operation CI-ControlWave XFC
cable (see Tables 2-2C & 2-3) can be connected between COM3 and the PC’s RS-
485 Port.
2.4.5 Display Assembly
In normal operation, the display stays on after the unit is configured and placed in service.
ControlWave XFC Display Assembly contains an upper row consisting of a
± LCD character
along with nine 7-Segment LCD characters, and a bottom row consisting of six 14-Segment
LCD characters. Signal values controlled by the “application load,” are posted to the upper
characters and signal names are posted to the lower characters.
Figure 2-26 shows the front of the CPU Board with factory installed Display Assembly.
JP1
CR2
CR1
IDLE
WD
LCD
Contrast
SW1
R43
Battery
Backup
General
Purpose
DIP
Switch
Figure 2-26 - ControlWave XFC CPU Board